I did finally get all the masking done of the projectile decks including the three spots on each where the hoists will be glued. I had a physically therapy appointment at 4:00 to work on my sciatica. I had to sand off the old Bondic and re-attach the piece. One of the rear compartment prints had the spanning tray break off…AGAIN! This piece had a very thin weak spot as the tray joins into the cradle at the faux hinge. Some of the components, which I thought were fully done, were “almost fully done” and required some additional cleanup. The next frustration kept occurring as I was adding pieces to the painting board. I think I’m just going to scratch build some spacers to close the gap. They were tough enough to get right the first time. I really don’t want to print another deck, nor do I want to mess with the drawing and print another set of three hoists. So now the lower deck’s hoists fit perfectly as shown above, but the upper hoists are anout 1/8" too short.
The two walls were intentionally different. In other words, I had forgotten that I had alredy accounted for this difference when printing them originally. Due to the large boss hanging down from the electric deck, the upper projectile flat wall height was shorter than the lower projectile’s deck. Then I found out why the two walls were different heights in the first place.
0 kommentar(er)
